Jump to content
Private Messaging is activated - check "How to" on how to disable it ×

Positionstoleranz und Abbildung 9-14


---
 Share

Recommended Posts

As far as i could understand from translated texts:
  • Don't mix True position with Perpendicularity
  • They allow max deviation of 0,15 on one of ends of cylinder axis in case of 0,0 perpendicularity
  • For max diameter ( 50,16 ) they allow max perpendicularity of 0,16 - and they are allowing bonus for True position ( 0,3 + 0,16 )
(M) in True position is not bad use here, but it can be without that bonus.
If OD ( base B ) is inserted to somewhere, then it needs True position. But that is another part with another drawing.
Link to comment
Share on other sites

OK, so again - don't compare Perpendicularity with True position.
True position covers:
  • Two coordinates ( here can be X and Y ) of both ends of cylinder from center of cylinder B
    The ID cylinder can be non-concentric with cyl B and still can be perpendicular to base A
  • Partial perpendicularity case ( in case cylinder is concentric with cyl B )
For ASME I don't know anything about RAME/UAME, but handleing (M) is covered by Calypso.
Both callouts are evaluated independently of each other.
Link to comment
Share on other sites

Please sign in to comment

You will be able to leave a comment after signing in



Sign In
 Share

×
×
  • Create New...