Autorun Auto Numbering System

[[Da...]]

I apologize for not knowing the exact terms, but here goes. I use auto run to measure 2,4 or 8 cavity molded parts at one time. So for instance I run a 4 cavity autorun, calypso will output the chr, fet and hdr files with a number addended to the end. So for instance I will see " 81-2587_revcc_18010_chr" 81-2587_revcc is my part # and rev which is the file name of my program. But if i run the 4 cavites all four parts are labeled with the 18010. Is it possible for that number to be incrementally changed for each cavity, vs. each pallet ran?

[[Ma...]]

I am missing a meaning of word "cavity" - lost in translation.
For part numbering there is autoincrement field "Part number".

[[No...]]

Let me be your dictionary 🤣
A cavity is one of several identical forms in a plastic or similar mold.
8 cavities = 8 identical parts made in one go.

[[Ma...]]

Please sign in to view this quote.

Thanks for your reply - now I have a little image of that meaning. Like from plastic models parts, ready to pop from frame to make a model of car.
So cavity on protocol is just number same as others - informing about position in mold? How it's different from "nest"?

[[No...]]

It isn't 🙂

[[Ma...]]

Then ... EXPLAIN!
EXTERMINATE! EXTERMINATE! 🤣 🤣 🤣
( Doctor Who for those who don't got it 😃 )

[[Da...]]

But when i run a program with 4 nests, it doesnt output each one as 1,2,3,4, it has them all as the same run.

[[Ma...]]

It has to be setup in autorun input.
I tryied this with cavity - so every fixture position can have pre-setted number for cavity - same for nest.

[[No...]]

Please sign in to view this quote.

But are you sure this number will show up in the name of the CHR etc. files? Because that's what Darren was asking for. I don't know unfortunately, because I don't use these files for anything and so never looked at how the filename is built.

[[Ma...]]

These filenames can be changed same way as PDF and others. I'll look if it can be entered into formula for name.

[[Ma...]]

So I checked the default names for the plan and you can add it to the formula.

getRecordHead("cavity")

In the autorun settings on the palette, edit the cavity number in all positions ( on 1. set 1; on 2. set 2; ... ) and that's it.

Or I didn't quite understand the problem.

[[Er...]]

In Calypso 5 it can be done through multiple printout.