[Ja...] Posted September 2, 2021 Share Posted September 2, 2021 Hello all, I'm sure something simple here, why after creating Base Alignment on Cad Model, is there an offset value in Z when remeasuring? This surface has been set to zero. Then a point created has the Nominal value with an offset, but the Actual value is correct. Is there a function I need to revise to have the Base Alignment and other features to match up? Thanks for any assistance provided. Link to comment https://qualityforum.zeiss.com/topic/12108-offset-on-cad-model/ Share on other sites More sharing options...
[SH...] Posted September 2, 2021 Share Posted September 2, 2021 Please sign in to view this quote. Can you give any screen shot?. Did you set your BA to zero?. Link to comment https://qualityforum.zeiss.com/topic/12108-offset-on-cad-model/#findComment-60548 Share on other sites More sharing options...
[Ja...] Posted September 2, 2021 Author Share Posted September 2, 2021 Hello, Should have known this would remedy this issue. After a computer and Renishaw controller shut down, Calypso and the probe readings are now in sync. Thanks. Link to comment https://qualityforum.zeiss.com/topic/12108-offset-on-cad-model/#findComment-60550 Share on other sites More sharing options...
[Ja...] Posted September 3, 2021 Author Share Posted September 3, 2021 After computer re-start, thought the issue was resolved, but still had same issue with point readings. Then recalled this setting shown below and after reset of new value Cad Model and points now match. Link to comment https://qualityforum.zeiss.com/topic/12108-offset-on-cad-model/#findComment-60552 Share on other sites More sharing options...
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in