Calypso Program Locks Up

[[Ja...]]

Hello,

At this time running Calypso 2017, Service Pack 7, with a DME connection to Renishaw UCC Controller on a LK Metre-4.

With this new set-up, most of the functions of Calyspo are working, except for when the it senses a bad probing or hit.

Calypso, immediately locks the program and I cannot access any features after clicking on the green light in the traffic window.

If an attempt to re-start the CNC run, an error message appears stating “Command is not allowed while execution of inspection”.

The only way to make the CMM active again is to close the current program and then close out Calypso also.

Has anyone see this before?

Thanks in advance.

[[Cl...]]

Try the "User Interrupt" (Ctrl Y) might get Calypso going again.