[Ja...] Posted April 20, 2021 Share Posted April 20, 2021 How do I turn this message off? I get them quite frequently. They're annoying and there's no way I'm scanning too fast. Link to comment Share on other sites More sharing options...
[SH...] Posted April 20, 2021 Share Posted April 20, 2021 Please sign in to view this quote. Could I ask, what characteristics you are evaluating?. Link to comment Share on other sites More sharing options...
[Ja...] Posted April 20, 2021 Author Share Posted April 20, 2021 I get the speed message on several features while programming, not any one type in particular. I've experimented with slowing down the speeds and/or changing data densities but it still keeps popping up. There doesn't seem to be a way of clearing the notification once it pops up so I'd like to turn it off altogether. Link to comment Share on other sites More sharing options...
[Jo...] Posted April 20, 2021 Share Posted April 20, 2021 What version of Calypso ? Link to comment Share on other sites More sharing options...
[Ja...] Posted April 20, 2021 Author Share Posted April 20, 2021 7.0.0803. This has been going on for quite some time. It didn't just start with this version. Link to comment Share on other sites More sharing options...
[Ja...] Posted April 21, 2021 Share Posted April 21, 2021 Please sign in to view this quote. Not a true answer to your question, but maybe it sheds a little light on what's happening. "Speed Subsequently Too High In certain cases, it may occur that the measurement results to be used for characteristic evaluation were recorded at an excessive speed. As a result, it will not be possible to achieve the desired accuracy. This can occur in the following cases: (A) You create a new characteristic after a measurement has already taken place. (B) You would like to evaluate a characteristic that is not contained in the list of characteristics of the measurement. CALYPSO checks the speed at which the measurement was performed. If this speed is too high for the new characteristic, the following message will appear: 'The speed used is too high for this Characteristic evaluation! Please measure the Feature again!' In this case, you will have to repeat the CNC run including the characteristic in question. The optimum speed will be re-determined taking the characteristic into consideration." Link to comment Share on other sites More sharing options...
[Jo...] Posted April 21, 2021 Share Posted April 21, 2021 Go into the strategy of one of the problem features. In the (speed, step width, points per section) area there is a tab at the top. CALCULATE , select that and see if it recalculates your speed or point density. This is the recommended speed, and I believe there also is a global setting over this. Link to comment Share on other sites More sharing options...
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in