[Ja...] Posted November 17, 2020 Share Posted November 17, 2020 We are putting in a new probe, and we are using Qualify Passive and then Geometry Requalification. After each one, we check and the Sigma value is all zeros. Any idea why this is happening? Link to comment Share on other sites More sharing options...
[Me...] Posted November 17, 2020 Share Posted November 17, 2020 You're probably looking at it in Inches, change to MM and see what your results are then because the number is going to be down to 4 places in metric if you've calibrated correctly. Link to comment Share on other sites More sharing options...
[Ma...] Posted November 17, 2020 Share Posted November 17, 2020 If it is because of inch / mm then it is quite a big soft issue. Link to comment Share on other sites More sharing options...
[Ri...] Posted November 17, 2020 Share Posted November 17, 2020 How many decimal places are you reporting? I would show a minimum of 4 if in metric, and 6 if in inches. Link to comment Share on other sites More sharing options...
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in