[Ja...] Posted October 28, 2020 Share Posted October 28, 2020 This is a Duramax, Calypso 6.8.08, Vast XXT, no RDS. I replaced a stylus #3 on a T shaped stylus. I deleted the old stylus system from the "stylus system management" so I am starting with a new stylus system. I calibrated the stylus #3 with no problems. I started the calibration on stylus #5 and it went through the normal routine fine until the end when the probe normally takes the final single points. Before it took the single points it traveled the the Z limit of the machine and then came back down to the reference sphere to take the single points. The calibration seems fine. I have verified the probes are functioning properly. I did not use a probe calibration program. I remember a previous post about this but I can not find it. Can anyone tell me what in the world just happened? Link to comment Share on other sites More sharing options...
[Ja...] Posted October 28, 2020 Author Share Posted October 28, 2020 I guess It's possible it happened with stylus #3 too, and I wasn't watching. Link to comment Share on other sites More sharing options...
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in
Sign In