[Lo...] Posted September 4, 2020 Share Posted September 4, 2020 Hello Everyone, I have tried setting the Z axis depth but I'm not doing something correctly. It will start probing in directions I haven't touched off. Is there a way to set the Z axis depth when checking a bore or circle and still using the same probing points originally setup? Thank you. Link to comment Share on other sites More sharing options...
[SH...] Posted September 4, 2020 Share Posted September 4, 2020 Go to the strategy window, set the co ordinate value of the points according to your requirements. Link to comment Share on other sites More sharing options...
[Da...] Posted September 4, 2020 Share Posted September 4, 2020 Go to your strategy and open the circle path, in the lower portion of that window you will see Start height, you can change the number in the box to move the circle up or down as you may need. Link to comment Share on other sites More sharing options...
[Lo...] Posted September 4, 2020 Author Share Posted September 4, 2020 Please sign in to view this quote. I just tried this out and nothing happen. I went from .001-.250 and the start height is the same. Link to comment Share on other sites More sharing options...
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in