[Za...] Posted April 25, 2020 Share Posted April 25, 2020 Hello all, I don't have to use this feature much, but we're getting more and more parts that have this same kind of setup, so I would like to use it more often instead of doing them one by one. I have everything setup, but I'm having some issues with the rotation/translation coming out correctly. Any help is appreciated. Here are the callouts and what I have so far: Link to comment Share on other sites More sharing options...
[SH...] Posted April 25, 2020 Share Posted April 25, 2020 Please sign in to view this quote. may I know why you are looking for a best fit alignment?all the datums in the drawing are not clear?? Link to comment Share on other sites More sharing options...
[Za...] Posted April 25, 2020 Author Share Posted April 25, 2020 When I report the True Positions separately, they come out fine, but the locations are not showing as 21.95mm away from the center of the 13.125 dia. I would prefer to report the True Position from the rotation at 45º so it lines up like in Pic1.png and reports the correct distance from the bore. In the spec callout, DatumA is the 13.125 Inside Diameter and DatumB is the Spotface (in this case it's the plane because we don't need a spotface due to the finish of the outside of the block). Link to comment Share on other sites More sharing options...
[SH...] Posted April 25, 2020 Share Posted April 25, 2020 viewtopic.php?f=13&t=183#p1313 Link to comment Share on other sites More sharing options...
[Za...] Posted April 25, 2020 Author Share Posted April 25, 2020 Please sign in to view this quote. This is where I started. I'm close, I just can't get the rotation/translation correct. Link to comment Share on other sites More sharing options...
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in