[SH...] Posted March 16, 2020 Share Posted March 16, 2020 I got a warning like this while creating a new program, I mistakenly made wrong alignment that is a root cause of this warning. My doubt is that what really automatic measurement means in this alarm??Screenshot_2020-03-16-23-03-25-65.png Link to comment Share on other sites More sharing options...
[Ch...] Posted March 16, 2020 Share Posted March 16, 2020 guessing you either did not select them at CNC run ( which I normally see a similar but not the same message); or perhaps they are set to MAN (manual) under "Measurement Plan Editor features" Man / CNC mode. Link to comment Share on other sites More sharing options...
[SH...] Posted March 16, 2020 Author Share Posted March 16, 2020 Actually I use tip no 5 instead tip no.3 , that is why I got this message. I made same mistake in the program also.l have been operating calypso for two years, still l make this mistake often. I checked the CNC start window, it was using points to points instead use clearance plane. Sometime calypso programming feel like fairy tale stories 😮 Link to comment Share on other sites More sharing options...
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in