Jump to content

Orientation Question


Recommended Posts

To answer the first question for A1/A2, yes.

As far as intersecting the 3 degree plane, I've tried intersecting, theoretical feature projections/intersections...Nothing gives me the orientation back to the slot though. I'm fairly confident it should be 90 degrees.
Link to comment
https://qualityforum.zeiss.com/topic/16464-orientation-question/#findComment-91628
Share on other sites

Please sign in to view this quote.

So Dave's idea.. If you change A1 A2 to angle instead of vector, one is 3 degrees and the other zero ? If you are leveled to keyway in that alignment, I think that zero is what you are looking for. If the key was rotated those A1 and A2 values would start changing.
Link to comment
https://qualityforum.zeiss.com/topic/16464-orientation-question/#findComment-91630
Share on other sites

Here is my .02

Intersect the 3º face (measured as a plane) with the large face on the back side that the angle call out is specified to (also measured as a plane). This will create a line that is nominally parallel to the center line of the slot that should intersect somewhere near your blue arrow. Call the 0º ± 5º from the created intersection to the centerline of the slot. I believe your nominal should be 0º rather than 90º

I sometimes have issue with reporting angles between two lines that are nominally parallel and will create a theoretical plane through one line (using a formula to recall angles). This may just be a shortfall in my grasp of the angles being shown so maybe I am the only one in the wide wide web that has a problem there.
Link to comment
https://qualityforum.zeiss.com/topic/16464-orientation-question/#findComment-91634
Share on other sites

×
×
  • Create New...