[Ro...] Posted April 15, 2019 Share Posted April 15, 2019 I just installed 6.6 on a couple of my Sheffield retrofitted machines, and noticed that CMM-Number is 000000000000. Is it possible to change that, and if so, where do I need to go, in order to change it?CMM Number.png Link to comment Share on other sites More sharing options...
[Kl...] Posted April 16, 2019 Share Posted April 16, 2019 Hello, the CMM-No is stored normally inside the Controller > Zeiss-Controller CZIMT-Service > I++ Connection Service installed the I++ connetion may know it Software-Support CALYPSO told me there is no file inside CALYPSO with CMM-No. Klaus-Dieter Link to comment Share on other sites More sharing options...
[Ri...] Posted April 16, 2019 Share Posted April 16, 2019 All of our CMM's show the last six digits of the serial number. There is also a PCM parameter that can recall the CMM serial number. getRecordHead("dmesn") Link to comment Share on other sites More sharing options...
[Er...] Posted April 18, 2019 Share Posted April 18, 2019 If its set to 000000 in your machine tab settings you wont get any thing else then 000000 back with dmesn. But you could try cmmInquire("sfmt(#cmm Number)") to see if something else is stored on your controller. Link to comment Share on other sites More sharing options...
[Ma...] Posted April 18, 2019 Share Posted April 18, 2019 It might be that your are using NZDI (non-zeiss direct interface) and the Sheffield controller Mark Link to comment Share on other sites More sharing options...
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in