Jump to content

Cylinder depth


Recommended Posts

Hello guys
Anyone observe this phenomenon
1)in calypso how much depth will consider as cylinder.
2) actually I have 1.8mm thickness plate in that I want create a cylinder in ID. but it's not measured still it's shows circle(taking min.8 points).then I am convert as cylinder.
3) if we convert as cylinder is there any inaccuracy will happen?
4) so what is the standard/min. depth for cylinder in calypso.
Link to comment
https://qualityforum.zeiss.com/topic/18896-cylinder-depth/
Share on other sites

Please sign in to view this quote.

Actually, inherent to any CMM software, there is something called "Short Unstable Datum's and Features".
At 1.8mm (.0709) the "A1" and "A2" values could cause projection errors.
It is highly unlikely that the thru hole is out of perpendicular but could report as slightly to out of tolerance for perpendicularity, in particular when projecting to a surface much farther away.
Link to comment
https://qualityforum.zeiss.com/topic/18896-cylinder-depth/#findComment-106398
Share on other sites

You can also take 2 circles, 1 at top & 1 at the bottom. Select cylinder from the feature menu. Open it & click on "options" & choose "recall feature points" select the 2 circles & it creates a theoretical Cylinder. I use this a lot for constructing cylinders on bores that are real shallow.
Link to comment
https://qualityforum.zeiss.com/topic/18896-cylinder-depth/#findComment-106400
Share on other sites

×
×
  • Create New...