[Jo...] Posted November 19, 2018 Share Posted November 19, 2018 Hello Everyone, I need your opinion on how to properly check a datum slot's MMC (length and width) and True position. Please see attached file. Any suggestions or advise will be very much appreciated.Datum C Slot.docx Link to comment Share on other sites More sharing options...
[Si...] Posted November 19, 2018 Share Posted November 19, 2018 Go to Forum Page 2, look for this post I put up last week "True Position at MMC for a SLOT???" I got good replies. Link to comment Share on other sites More sharing options...
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in