Jump to content

Dimesion Inspection


---
 Share

Recommended Posts

I am trying to measure thickness in a certain section.

I have used INSPECTION -> Check Dimensions -> Positions -> Check dXYZ.

If I check "Consturct 2-Point Line" the distance is 0.7600 in normal and 0.6848 in Actual. This should give me Dimensions (Scalar) of 0.0752 but the result is shown as 0.0085. Why would this happen?

 

 

Link to comment
Share on other sites

I noticed that there is an error.

The alignment is not valid in this stage.

How can I correct this error?

 

Link to comment
Share on other sites

Hello Yon,

looks like you found the error. Maybe the dedicated tools for material thickness in our software are worth a look?

Regards,

Nanno

Snag_3b8590a6.png

Link to comment
Share on other sites

 Share

×
×
  • Create New...