[Cl...] Posted September 10, 2018 Share Posted September 10, 2018 I started programming on Virtual DMIS 18 yrs. ago. The way I was taught in VDMIS was to rotate to each hole, and report the X&Y deviations. I see Calypso has an option called "Best fit bore pattern" I have never used this option. Does it accomplish the same thing w/out the multiple rotations? Link to comment Share on other sites More sharing options...
[Cl...] Posted September 10, 2018 Author Share Posted September 10, 2018 Not getting any takers on this one? Link to comment Share on other sites More sharing options...
[Mi...] Posted September 10, 2018 Share Posted September 10, 2018 I do not use BP much but yes I do believe Calypso does all the rotating etc.. when you use the BP and insert all the datums etc.. Calypso can graph it as well... Link to comment Share on other sites More sharing options...
[Cl...] Posted September 10, 2018 Author Share Posted September 10, 2018 Thanks Mike. Link to comment Share on other sites More sharing options...
[Za...] Posted September 10, 2018 Share Posted September 10, 2018 Link to comment Share on other sites More sharing options...
[Cl...] Posted September 10, 2018 Author Share Posted September 10, 2018 Got it, thanks! Link to comment Share on other sites More sharing options...
[Ch...] Posted September 10, 2018 Share Posted September 10, 2018 Here is a little tid-bit. I use this to output graphs for the machinist. You can turn off all rotation and translation. If you suck with numbers and can't read a cmm report, then you should atleast be able to look at a picture and tell if the pattern is good or not.borepattersnip.PNG Link to comment Share on other sites More sharing options...
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in