[Je...] Posted May 18, 2018 Share Posted May 18, 2018 I keep getting this error when i go to run a certain program. It only occurs on 2 features that are using that stylus and within the same clearance group +Z. The setup is Calypso on an older Mitutoyo with a Renishaw Probe. Error: 409-Y-Axis out of volume Link to comment Share on other sites More sharing options...
[To...] Posted May 18, 2018 Share Posted May 18, 2018 My initial thought is that you're on a Y limit of the machine. Link to comment Share on other sites More sharing options...
[Je...] Posted May 18, 2018 Author Share Posted May 18, 2018 I should of noted, I'm no where close to any machine limits. Link to comment Share on other sites More sharing options...
[To...] Posted May 18, 2018 Share Posted May 18, 2018 Can we assume the X/Y/Z axis of your part alignment is somewhat normal to the X/Y/Z of the CMM? Link to comment Share on other sites More sharing options...
[De...] Posted May 18, 2018 Share Posted May 18, 2018 One thought I have is before it drives you too crazy have you tried recreating the feature? Perhaps it just got corrupted? Link to comment Share on other sites More sharing options...
[Je...] Posted May 18, 2018 Author Share Posted May 18, 2018 So far i've recreated the feature, did 400 power cycles. I had Zeiss Tech Support look into it, all with no results.Last thing is i'm doing a software update to see if it's a bug with the Calypso/Mitutoyo set-up. Link to comment Share on other sites More sharing options...
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in