[Me...] Posted April 17, 2018 Share Posted April 17, 2018 Hi All, Is it possible to change the 0° home position on an RT? I know that you can change it at the beginning of a program, but I'm looking for a permanent change, not a per program change. Link to comment Share on other sites More sharing options...
[Za...] Posted April 17, 2018 Share Posted April 17, 2018 this? Link to comment Share on other sites More sharing options...
[Me...] Posted April 17, 2018 Author Share Posted April 17, 2018 I will test and report back! Thank you! Link to comment Share on other sites More sharing options...
[Me...] Posted May 10, 2018 Author Share Posted May 10, 2018 This apparently just homes the RT, it doesn't allow you to change the 0° point. 🙁 Anyone else have any suggestions? Link to comment Share on other sites More sharing options...
[He...] Posted May 16, 2018 Share Posted May 16, 2018 You will have to contact Zeiss and have them change the homeposition of the rotary table in the machine controller. Link to comment Share on other sites More sharing options...
[Me...] Posted May 18, 2018 Author Share Posted May 18, 2018 Dang. I asked the tech when he was here to calibrate it, and he didn't know if that was even possible. Lol. Oh well. Link to comment Share on other sites More sharing options...
[Me...] Posted May 18, 2018 Author Share Posted May 18, 2018 I don't know how to perform the task, but it is possible. There are service technicians that are trained to a specific procedure for offsetting the 0° position. I would contact Zeiss and request one of those service techs. Link to comment Share on other sites More sharing options...
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in