Rectangle XY tolerance for True Position of Bore Pattern

[[Ge...]]

Hello ,

I have a problem with Rectangle tolerance frame when I measure a true position of a bore pattern. The tolerance frame doesn't rotate with pattern . In the drawing I have tolerance : 0.3 circumferential and 0.5 radial !

[[Er...]]

The software is doing exactly what you told it to. 0,5 in Y, and 0,3 in X.

[[Ge...]]

Ok, then I have to reformulate ; how can I do in Calypso the rotate of the tolerance frame ( to follow the Radius and Angle ) ?

[[An...]]

_

[[Ge...]]

Attached !

Capture position.PNG

[[An...]]

_

[[Mi...]]

I think he wants to evaluate the tolerances like this.

0226_001.jpg

[[An...]]

_

[[Ge...]]

Thank you very much for your description but I don't think that this it's simple to apply. I think that Zeiss should consider to make some change in this direction .
I think that it wood be much simple if I will do a simple True Position of every bore related to center of the ring and just rotate the base alignment, according to the drawing and use Rectangle tolerance frame .

[[Te...]]

Is that even a legit call out? Whenever I have seen position without the Ø, it applied to only 1 axis, like position of a slot width. Does that call out really mean a square zone or is it just a bad call out?

Just curios....

[[Aa...]]

You could consider it an equivalent of what Y14.5 refers to as a bidirectional tolerance, using the polar coordinate method. (See Y14.5-2009 Figure 7-29 and 7.4.4.2.)