User-defined Tolerance Table

[[Jo...]]

Hi

I've made a user defined tolerance table with mold-dependent tolerances as well as mold-independent tolerances.

When I set that tolerance table and apply tolerances automatically from it, it always sets values from mold-dependent tolerances. Is there a way to set them accordingly to what they are?

I'm using GOM 2019.

 

Thanks,
José Oliveira

[[Ch...]]

Hello,

 

do you have set your actual element to the correct value, as shown in the following screenshot:

 

Note 1: Screenshot is taken from GOM Software 2021, but in GOM Software it should have a similiar appearance

Note 2: Yes we know that a better place (in sense of accessbility) would be the tolerances itself.

 

I hope this solves the problem. Otherwise I would suggest that you contact your local partner to get further support.

 

Best regards

Christoph Schult

[[Jo...]]

Ok, I see it
I was looking in the labels properties, not elements.

Thank you very much.