Local best-fit with tolerances - expert parameter - Use all selected points

[[Má...]]

Dear All!

I found in the techguide description that if the "Use all selected points" function is turned off, the software does not use all the points at "Local best-fit with Tolerances". The question is, how many points does it use in this case?

 

Best regards,

Máté

[[Je...]]

Hello Mate,

about 5%.

Best regards,

Jens

[[Já...]]

I have the issue that sometimes, even though I apply the "Use all selected points", I still get some penetration (negative surface deviation). The image shows a dental crown design (green, actual) seated on the abutment (prepared tooth, nominal). How can we totally avoid this?

Best Regards, Janos