[Al...] Posted April 16 Share Posted April 16 I just recently upgraded to Calypso 2024 from 2019, I am trying to figure out how to setup two surface profiles using simultaneous requirement. I browsed through some of the other forum topics but I can't figure out how to get it setup correctly. Link to comment Share on other sites More sharing options...
[Ma...] Posted April 16 Share Posted April 16 I am not sure if this is correct, but you can use freeform - recall all measured points into this one and in evaluation of freeform make alignment. Or this freeform can be used as one feature for profile callout. I don't get sim callouts, so i am not used to it and i didn't get head around that. Link to comment Share on other sites More sharing options...
[To...] Posted April 16 Share Posted April 16 Please sign in to view this quote. whenever there are multiple DRF's with the same structure, that is not fully constrained, or has MMB/LMB, they must all be evaluated simultaneously. In other words, one position can't datum shift in one direction and another position shift in another direction. Link to comment Share on other sites More sharing options...
[Al...] Posted April 16 Author Share Posted April 16 Please sign in to view this quote. I figured out what I was doing wrong. When I was creating the two different profiles, I didn't have the datums set up identically. My Datum A for Profile 1 and Profile 2 were being evaluated differently so it wouldn't show the SimReq tab. Link to comment Share on other sites More sharing options...
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in