[Do...] Posted Tuesday at 02:48 PM Share Posted Tuesday at 02:48 PM So I have this callout shown in the attached image and I am trying to make sure that I have the CMM looking at it correctly (see IMG_5489). I do not deal that much with unequally distributed profile callouts so I am a little unsure of how they get programmed. Link to comment Share on other sites More sharing options...
[Cr...] Posted Tuesday at 03:21 PM Share Posted Tuesday at 03:21 PM In this callout .010 designates outside (Stock on) .010 should be where you have the .040 and the button next to it should be flipped to outside 1 Link to comment Share on other sites More sharing options...
[Ma...] Posted Tuesday at 03:29 PM Share Posted Tuesday at 03:29 PM Link to comment Share on other sites More sharing options...
[Do...] Posted Tuesday at 04:51 PM Author Share Posted Tuesday at 04:51 PM Please sign in to view this quote. If I am measuring the surface indicated by the red arrows, and it is in the -Y axis do I need to toggle the button (next to purple arrow) the other direction to show the .010" going outward in the -Y direction from the material surface. Or does this button always need to stay as shown in image no matter what or where the surface lies in relation to the axis (vector) it is being measured in? Link to comment Share on other sites More sharing options...
[Ma...] Posted Tuesday at 05:06 PM Share Posted Tuesday at 05:06 PM I think you have it set correctly. Tolerance band should be 0,01 out of material and 0,04 in material ( material is drawn as green area on that button ) 1 Link to comment Share on other sites More sharing options...
[Cr...] Posted Tuesday at 05:11 PM Share Posted Tuesday at 05:11 PM If you turn on bubble help under the -?- dropdown and hover over the button you have a purple arrow to, it shows you this button switches from inside (stock off) to outside (stock on). This should not matter where the surface lies in relation to your DFR. I believe your original setting would have worked (I haven't tested this) but the callout designates .010 as being outside (stock on). Link to comment Share on other sites More sharing options...
[Do...] Posted Tuesday at 05:29 PM Author Share Posted Tuesday at 05:29 PM Please sign in to view this quote. Yes, you would be correct. The intent is no more than .010" outside (stock on). Link to comment Share on other sites More sharing options...
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in