Maschine is slower after upgrade to 8.0

[[Ma...]]

Hello everyone,

we have updated our Calypso from 6.8 to 8.0 (and new computers as well).
 Since the update, the runtime of our programs has significantly increased.
 A program that previously ran for approx. 60 min now takes 80 min.
 After each measurement element, the CMM briefly stops and calculates.
 Do I need to change something in the settings or have the paths changed?
 After the reinstallation, we adopted the 6.8 config one-to-one.
 Unfortunately, support also had no advice.

Thank you very much.

[[Wo...]]

See the Calypso 8.0 thread, the issue has been discussed there. Apparently, the next service pack is supposed to fix that. I've not been able to find a fix in the settings, but it was noticed that the slowdown is present on the probeheads with rotation capability (RDS,XTR), but not on Vast XT. If it's too late to roll back to previous version (7.8 works OK), then the only option is to wait for the next service pack as far as I know.