[Da...] Posted October 29 Share Posted October 29 We have a very magnetic part to check. It registers 5-8 gauss at 8 inches from the part! I have carbon probes and extensions that seem to Not stick to the part. My concern is ,Can the vast XT get Within 8 inches without being affected? Link to comment Share on other sites More sharing options...
[An...] Posted October 29 Share Posted October 29 Jeff Penrod discusses inspecting magnetic parts in this thread. Your high end of 8 Gauss is 0.8mT, which suggests it may be OK. In this instance, to minimize the chance of damage, I would suggest reaching out to ZEISS hardware support. 1 Link to comment Share on other sites More sharing options...
[Da...] Posted October 29 Author Share Posted October 29 Thanks so much, I remember asking this before but didn't remember the response ! Link to comment Share on other sites More sharing options...
[An...] Posted October 29 Share Posted October 29 Whoops, I didn't even realize that you were the author of the original post! Mea culpa Link to comment Share on other sites More sharing options...
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in