Planner 8.0

[[Jo...]]

Just installed calypso 2025 on my offline seat.  Set everything up... machine tabs, rotary table, etc...  Lots of problems...  1) when opening program, work piece looks to be 6-7" into the machine. 2) Cannot probe the machine "plate surface" 3) trying to establish RT... if I open the base alignment and do a manual alignment, it flips the part about 105 degrees towards the back of the machine... if i just open then close and let the machine do it, it will flip the part 180 degrees (upside down).  I have been doing the planner since 4.0 and never had this before.  I contacted Zeiss but thought maybe someone has had this happen...    Note all my machines are on 2020 with a RT01 and not an AB... I don't know if this is what causing the issues (can't see why because its virtual on planner)

[[Ja...]]

It's been a big headache for me and several others too. And it's not just 1 problem - It seems to affect different machines differently. For me, the execution mode is insanely slow. Sometimes it will take a single feature 10-20 minutes to execute.