Jump to content

GD and T General question


Recommended Posts

True positions don't have to fully constrain a part.  You can TP to one datum if youd like (You get only perpendicularity, but its legal).  The positions apply with whatever constraints are offered. 

 

Since datums consume constraints as they are available, you need more information than just ABC to help more. 

 

 

Edited
  • 3 weeks later...

So this is a funny situation.  It's not wrong but could lead to trouble.

Datum C provides only clocking.  All of the other 5 DOF are constrained.

Datum C remember is NOT the hole itself.  Its DFS will be a best fit pin mutually parallel to B and perpendicular to A.  Whatever size that best fit pin is when constrained for orientation, its CL is the clocking datum.

You could start this hole perfectly on position but if the drill walks and the hole isn't perpendicular to A, I suspect an evaluation of TP with C tertiary would yield different results than the same evaluation with no tertiary.

It is possible to have the C feature machined OOT for TP using C as tertiary because DFS's have perfect form and orientation while your feature will not.

 

×
×
  • Create New...