True Position

[[AG...]]

Just curious about how anyone would set this up? I am in discussion with the engineer as in he believes that this part is in tolerance as i am getting OOT. I have been discussing this for a day and a half and i might be confusing myself, running in circles? I am setting it up as shown with alignment as A datum, all dims come from the A datum plane in the X axis. The B datum, all dims come from the B datum in the Y axis. In the two separate alignments i have for these i am using the A datum in the X and the Top plane as my Z. The same thing for the B datum alignment, i am using the Y for my B and the Top plane as my Z. When i use Best Fit alignment, i am reporting a good part, i explained how Best fit works and he is not sure of it. In my past endeavor's i used Best fit for a hole pattern like this all day, no issues. I see this as a Best Fit scenario, am i incorrect? Just because the hole pattern is of course the important part. Thank you in advance for any direction or if i am just overthinking this scenario.

  

[[Ma...]]

If A is in -X vector, then report TP|A only X and for TP|B only Y ( or Z i don't know )