[Ju...] Posted yesterday at 01:07 PM Share Posted yesterday at 01:07 PM Has anyone else had issues scanning in 2026 with a ScanHawk2? Even after installing the new SP1 it still has issues scanning. I In 2025 with a single pass its working normal but with the same setting and same single pass 2026 will not scan. Link to comment Share on other sites More sharing options...
[Pa...] Posted yesterday at 01:57 PM Share Posted yesterday at 01:57 PM I just scanned a bit of a part today and I'm seeing the same issue as you. The scanned surface looked more solid after a scan in the earlier versions. I even called my supplier to ask about it, but they couldn't say why it was such difference. Link to comment Share on other sites More sharing options...
[Ch...] Posted 5 hours ago Share Posted 5 hours ago In 2025 once a point was measured it was visualized with full splat size and fixed normal. In 2026 the visualization of scanned data changed slightly; splats adapt over time. The more a often point is observed the bigger the representing splat gets. This should give an indication where data is measured sufficiently to get a good mesh without holes. So if you just do a single quick scan on a surface you'll get porous visualization. Link to comment Share on other sites More sharing options...
[Ju...] Posted 5 hours ago Author Share Posted 5 hours ago The scan was very slow so it should not be porous Link to comment Share on other sites More sharing options...
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in