MasterProbe (XXT)

[[Cl...]]

I created a new tab in planner. Opening a program, I checked the MasterProbe geometry and its wrong? Wrong vector direction and no radius?

 

Edited 22 hours ago

[[To...]]

Not a new situation.  I always edit the R to 2.5 and move on.  Doesn't seem to come into play until you start defining holder locations on your probe rack.

[[Cl...]]

What about the vector? I can't edit that.

[[Je...]]

At my planner seat with vast XTR I can change the vector..

but you can try with PCM:

setNewGeoStatToActualProbe(0,0,0,0,0,-1)

setNewRadiusToActualProbe("2.5")

that should work

[[Cl...]]

Thank you Jens. Where do I insert this code?

[[Je...]]

Please sign in to view this quote.

make sure, that you have the needed probe changed in

do you have pcm?

plan->Advanced->PCM Editor

copy the code into the editor, mark it, and press the calculate-button (an arrow inside a gear-wheel)

 

without pcm you can write a small program (with your master probe) with two characteristics with conditions.

in them just write something like setNewGeoStatToActualProbe(0,0,0,0,0,-1)=="GG" and setNewRadiusToActualProbe("2.5")=="gg", select "yes" for end program, and run that program offline

Edited 1 hour ago

[[Cl...]]

Success! Thanks again Jens!