How to report intersection point (cylinder and cone)

[[K...]]

Please see the picture:

I measured cylinder and cone, constructed intersection point (cylinder and cone).

But unable to reported measured data of intersection point.

How to report measured data of intersection point w.r.t. datum line. 

Please let me know how to create a characteristic (height of point) of intersection point w.r.t to datum axis.

[[Jö...]]

Hallo K-Zack,

vielleicht hilft Dir das. Finde leider den Original Beitrag nicht mehr. Ist schon eine Weile her.

[[Sv...]]

Measure the cylinder and the cone. Then select the intersection point of both elements and project both onto their respective lateral surfaces. This yields the intersection between the cone and the cylinder, allowing you to evaluate the bottom plane and the intersection using a caliper distance measurement.

[[Ri...]]

Use "Cone calculation".