Probing system qualification Modes grayed out

[[Be...]]

The title says it all.  I am attempting to set up a re-qualification measurement plan and from our training manual, I am supposed to switch the Mode from Tensor to Geometry Re-qual.  Unfortunately, my only available options are Tensor, Dyn.tensor, and 6 Points.  Everything else is grayed out.

[[Ma...]]

It has been awhile since I've created one but If you are creating a qualification program you would use this I believe.

I believe your mode by default will be what your last qualification you had set.

You might be able to change if you open the Probing system qualification characteristic.