scan speed on the Vast XXT

[[Ji...]]

Hi folks,

What scan speed are you running on Vast XXT? How do you decide the value? Just follow the cookbook?

[[Ka...]]

Well, it depends..
We mostly stick to the cookbook.
If the surface is rougher, we’ll sometimes use just 3 mm/s if it clearly yields better results.
The speed with XXT sensors is also generally quite slow—somewhere between 3 and 10 mm/s. If possible, we use a 3-mm ball, but often the components are too small, and we need 1.5-mm or even 0.8-mm balls. All in all, if you have time, it's worth trying out different speeds to see how the results change when using the same filters.

[[Sv...]]

We also largely stick to the standard procedure for inspections. In serial production, timing does play a role, after all. I adjust my approach depending on the specific feature involved; I measure a precision fit more slowly than a drilled mounting hole. The diameter matters, too—I scan larger diameters faster than smaller ones. And, as Karsten mentioned, I run tests: I use 1, 1.5, 2, 3, and 4 mm probes as well as disc styli.

[[Lu...]]

I follow the cookbook but i run aditional tests and in my tests you can increase more then 50% more speed then recomended in cookbook

the better way for circular scans circles u run one with max values on cookbook u create a local aligment in hat circle and u run additional scans with incresed speeds and you should look for diameter x and Y coordinates of the center and error form.

this way you can have a good idea how far you can go between precision and speed. 

For filters i use from cookbook.

 

im using this values