Jump to content

Evaluation of 2 CAD's and 2 Point Clouds - Simulation


Recommended Posts

Hello everyone,

 

As you can see in the image attached, I can make an evaluation with 2 different CADs and 2 different point clouds to check the interference (circle red) between 2 parts, and it runs perfectly.

 

I would like to ask if it is possible to change the CAD position to simulate how the part will work. For example, I want to move Part 1 in the X direction 1 mm to check if the interference will be better or worse.

 

I know that it's possible to do that if the engineering department changes the CAD position, and I will need to do the same evaluation, but I want to know if it's possible to do that directly in Zeiss Inspect.

 

Thank you, everyone.

INTERFERENCE.JPG

Please sign in to view this username.

 "Select all points" of the CAD. Operations>Alignment>Single Element Transformation>Set Matrix. Uncheck "Set transformation in section views". In the translation section, adjust the X-axis position as needed.

Screenshot 2026-11-18 081250.png

Edited
  • Like! 1
×
×
  • Create New...