[Ri...] Posted Wednesday at 04:45 PM Share Posted Wednesday at 04:45 PM (edited) What would the flatness of the granite surface be for a Contura 6206 7/12/6? All I could find is AI information. Please sign in to view this quote. Edited Wednesday at 04:45 PM Link to comment https://qualityforum.zeiss.com/topic/27900-contura-6206-granite-flatness/ Share on other sites More sharing options...
[Wo...] Posted 12 hours ago Share Posted 12 hours ago I was wondering if the flatness of the granite is actually required for CMMs. After all, unless you are probing granite, it takes no part in measurements. If I need to measure something off of granite, I place a qualified plate on the CMM and use that. It's not checked during calibration too. Is this correct or do I misunderstand something? Link to comment https://qualityforum.zeiss.com/topic/27900-contura-6206-granite-flatness/#findComment-158470 Share on other sites More sharing options...
[No...] Posted 50 minutes ago Share Posted 50 minutes ago Please sign in to view this quote. Basically correct, but at least in the zone of the air bearings flatness matters, as any deviation directly affects the geometry of one or more axes. That's what CAA is for. Link to comment https://qualityforum.zeiss.com/topic/27900-contura-6206-granite-flatness/#findComment-158474 Share on other sites More sharing options...
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in