Advice on filtering mesh

[[Br...]]

I just scanned a stamping die today, which is a bit new for me. Can anyone give me advice on filtering the scan? I figure there may be a little noise or even some areas where I may have sprayed too much and created a small drip effect that needs to be filtered.

I dont want to go overboard. Can anyone give me a little guidance on how to do so and how much?

I have been reading the tech sheets on filtering the mesh, but it would be good to get some real world input.

Thank you. 

[[Lu...]]

Hi Brad,

Daniel from our training department has created an "It's a Hack" episode where he shows how to easily edit a mesh via thinning and smoothing.

https://www.youtube.com/watch?v=L_FmMB2zO7c

Unfortunately, it's not possible to specify exactly how much and how you need to filter. It depends a lot on how much information you can lose, what tolerances you have etc... 

I hope this information helps you for now.

Best regards
Lukas