Jump to content

MMC vs MMB


Recommended Posts

Yes, basically you are correct.

This example should help.  You have a car rotor below. The 5 holes are located from the center hole(Datum A) in a dashed diameter basic callout on the print. And they should be all separated from each other by a 72 deg basic callout on the print.

 

Now imagine you are slipping this rotor over a center boss with 5 bolts coming out. The larger you make the rotor Datum A the more you can jiggle the rotor around until it slips over the 5 bolts. It is in your best interest to make this rotor Datum A as far from MMC as possible so you can move the rotor around more until it fits. If you are measuring these bolt holes on the rotor on a CMM or something know that you need to measure all the holes as a patten when using datum shift b/c you only get one Datum shift not 5 individual datum shifts to make the location of the 5 holes as good as possible...

 

 

rotor.jpg

  • Like! 1
Link to comment
https://qualityforum.zeiss.com/topic/5042-mmc-vs-mmb/#findComment-56526
Share on other sites

  • 2 weeks later...
  • 6 months later...

Then MMB ( which is on datum B ) is allowed to move within it's tolerance - no other feature is comming into a play.

Then there is MMC, which is allowed expand of callout's feature/s tolerance. In other words - you will see possible change in tolerance size only for MMC ( feature ) and not for MMB ( datum )

Link to comment
https://qualityforum.zeiss.com/topic/5042-mmc-vs-mmb/#findComment-133463
Share on other sites

×
×
  • Create New...