CALYPSO 7.8 Freeform Stylus Pause

[[Ch...]]

In CALYPSO 7.8 a Freeform, Number of Points / Stylus Pause, issue was discovered.
If "Number of Points" is toggled within the strategy of a Freeform Point Set the probe will often delay or pause while in contact with surface of the part. Simply toggle the strategy to “Step width” and the issue will not occur.

CALYPSO Development is currently working to resolve the issue but wanted to post it here in case anyone else runs into it.

[[Ma...]]

I wish to have more posts like this from now on. There is no informations like this in patches - just a little mention in patch notes.