Circle on cone

[[Ma...]]

Hello
I am measuring a inside circle on cone in Calypso 7.2.0 and sometimes it starts beside the hole and drags the probe in to the hole before it starts measure. I tried to change to outside measurement as a test but the it stops for collision when it reach the face.
It doesn't stop when I use inside.

Any ideas?

[[Ro...]]

What's your retract distance?
Go into Measurement plan editor and select "Probing" then "Search distance before nominal position" and put a large number in there, say 0.100" or 0.200". That'll force the machine to start back a ways and slowly glide into probing position.

fdjshgfvdhjsgsdgfdkjsgfd.PNG

[[Ch...]]

Is the nominal position of the hole correct? If so it should at the very least start in the middle. If you haven't installed a CALYPSO Service Pack as of yet it may be worth while to ensure you aren't encountering any bugs: https://portal.zeiss.com/knowledge-base?id=860897

[[Ma...]]

I will try the latest servicepack and se if it solves the problem.

The search distance didn´t help.

The strange thing is that if I change to circle it works, change back to circle on cone ..doesn't work.

Lets hope that the service pack do the magic,
Thanks for your tip

[[Ri...]]

Please sign in to view this quote.

I would think the vectors are wrong.
If its an ID, the vectors should be toward the inside of the feature, this seems like they are pointing outside the feature.

[[To...]]

can you post a screenshot of the feature window? Also, what are your clearance distance and retract distance values?