[Go...] Posted March 14, 2023 Share Posted March 14, 2023 Hello to all, Could somebady tell me how to aplicate this about a circle element? thank you so much for your comments.ejemplo E.JPG Link to comment Share on other sites More sharing options...
[An...] Posted March 14, 2023 Share Posted March 14, 2023 you should measure your diameter as an envelope circle and also output the two point measurement. In addition to the envelope circle, the largest / smallest dimension is then output in the log. Link to comment Share on other sites More sharing options...
[Da...] Posted March 14, 2023 Share Posted March 14, 2023 If you take the envelope condition seriously, then you would want to measure the feature as a cylinder! The envelope condition applies for the whole length of the feature. Link to comment Share on other sites More sharing options...
[ni...] Posted March 14, 2023 Share Posted March 14, 2023 hi, enveloppe is an ISO's modificateur , it's like rule #1 in ASME Link to comment Share on other sites More sharing options...
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in