[Fl...] Posted September 28, 2022 Share Posted September 28, 2022 How i should report surface profile - not line profile? So more curves into one surface. I don't know (i make the curve, the general surface and how? ). I attached the photos with the drw. request.drw req.JPG Link to comment Share on other sites More sharing options...
[Cl...] Posted September 28, 2022 Share Posted September 28, 2022 I usually do one of two things. Either scan multiple 3d curves, recalling them into a Freeform Surface, or I go to: CAD - Creating features - Point Set - Freeform Surface From face(s). Does that help? Link to comment Share on other sites More sharing options...
[Fl...] Posted September 29, 2022 Author Share Posted September 29, 2022 Thank's for answer but i have a problem. I don't have freeform options available. Is possible with general surface or another method? Link to comment Share on other sites More sharing options...
[Cl...] Posted September 29, 2022 Share Posted September 29, 2022 I got this off the forum a while back, should help with your problem. Link to comment Share on other sites More sharing options...
[To...] Posted September 30, 2022 Share Posted September 30, 2022 Please sign in to view this quote. This document states that this only works if you have a fully constrained DRF Link to comment Share on other sites More sharing options...
[Ia...] Posted October 4, 2022 Share Posted October 4, 2022 Please sign in to view this quote. What if you made a best fit alignment, and made all your space points aligned to that? Just curious. Link to comment Share on other sites More sharing options...
[To...] Posted October 4, 2022 Share Posted October 4, 2022 Please sign in to view this quote. I believe that is a common workaround. Link to comment Share on other sites More sharing options...
[Fl...] Posted October 5, 2022 Author Share Posted October 5, 2022 Thank you all for the replies, but I haven't received anything relevant. I am telling my method, how I proceed, and if I am wrong somewhere, please correct me: 1) I do a scan with 2 d lines 2) I evaluate this scan (features) with line profile and best fit 3) because I need to choose something in the features box (line profile, see picture). now I chose linear projection,,best fit, and in the box with Evaluation (see photos) for stylus radius correction I chose nom. Spline. is OK? Do I need to change something, check something? Thank's20221005_094542.jpg20221005_094531.jpg Link to comment Share on other sites More sharing options...
[Ma...] Posted October 5, 2022 Share Posted October 5, 2022 I would sugest make more of 2D/3D curves ( 3D if it is rotary part ) then from Resources -> Utilities -> Alignment from Several Curves - select all curves, set options ( translate, num. of points used ) then report general surface to this alignment. Link to comment Share on other sites More sharing options...
[Fl...] Posted October 5, 2022 Author Share Posted October 5, 2022 thanks for answer. I did but I can't find it: set options ( translate, num. of points used ) then report general surface to this alignment. thanks in advance Link to comment Share on other sites More sharing options...
[Ma...] Posted October 5, 2022 Share Posted October 5, 2022 Here is screenshot from pdf manual of Calypso 2021 Link to comment Share on other sites More sharing options...
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in