[Ja...] Posted March 3, 2021 Share Posted March 3, 2021 When entering probe parameters for each stylus system such as A angle, B angle, radius, and shaft radius, are the units in my environment units? If I use inches should these radii be input as inches or as mm? Also, does the shaft radius have an effect on the calculation of bending forces in the stylus? There is a tip that somebody had put a shaft radius of 0 when setting it up and a new tip is giving much different results. Link to comment Share on other sites More sharing options...
[Ja...] Posted April 16, 2021 Author Share Posted April 16, 2021 Is there anybody out there? Link to comment Share on other sites More sharing options...
[Cl...] Posted April 16, 2021 Share Posted April 16, 2021 Bueller............Bueller? Link to comment Share on other sites More sharing options...
[Jo...] Posted April 16, 2021 Share Posted April 16, 2021 AFAIK my probe data under Geometry tab is always in mm . If you getprobe dia it is in mm as well. My environment is in inches. Go to Cad>Cad model control>show probe. The generic probe graphic should be to scale. Link to comment Share on other sites More sharing options...
[Er...] Posted April 17, 2021 Share Posted April 17, 2021 I was waiting to see what the answers were. Good questions. Link to comment Share on other sites More sharing options...
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in