Jump to content

SSC DATA, SIMULATION FILES


---
 Share

Recommended Posts

Hello,

I was wondering if anyone could assist or point me in the right direction with the measurement plan simulator on my offline seat.

So I loaded the my RC stylus information from one of our online seats, then I imported the .pcf file to get all the geometries.

Now I would like to import the .ssc file to the correct stylus for simulation purposes while keeping the stylus geometries.

This is what I have tried.
Planner/Import SSC File/Load System/Accept Loaded SSC File. Then I select the the correct stylus system. When I do this, the simulation model in present but I have lost all my geometries. When I go back into the geometries and import the .pcf file I then lose the stylus creation model.

I've only been working with Calypso for about 7 months now, so any information will be greatly appreciated.
Thanks in advanced.

Regards,

Michael
Link to comment
Share on other sites

Stylus System can only have one name and can't be duplicated

I had a case where I was setting up an offline seat for a customer and I had them send me the .pcf files so I had the correct names and all the rotations and pictures with dimension of all the stylus systems .

After I loaded the .pcf files I copied them each one and added the letter A to the end of all of them. Then I deleted the original ones without the A.

Went to stylus builder and created the stylus system using the correct name without the extra A at the end.

After importing them I went thru each one and add all the rotations using the stylus system with the A at the end to add the rotations and names.

Was a pretty easy task.

I have attach my Creating RDS Stylus List Guide I give my students so you can see how I added the rotations from the pre existing stylus systems.

Hope this helps

Creating RDS Stylus List 2018 Rev 01A.pdf

Link to comment
Share on other sites

 Share

×
×
  • Create New...