[Ma...] Posted August 5, 2020 Share Posted August 5, 2020 Hello All See Picture below, (excuse my bad paint skills). I am struggling to measure coplanar. I have been trying to set this up with profile but i cant seem to figure it out. The Blue highlighted plane is the datum, the red highlighted planes need to be coplanar to it. Essentially ensuring there is a max overhang/underhang of 0.1mm. Any advice on how I should go about measuring this correctly would be greatly appreciated as I seem to be going around in circles. Thank you in advanced. 🙂 Link to comment Share on other sites More sharing options...
[Mi...] Posted August 5, 2020 Share Posted August 5, 2020 Scan each plane, create a Minimum Point and Maximum Point on each one, then report perpendicular distance of each point to the datum. Link to comment Share on other sites More sharing options...
[Jo...] Posted August 5, 2020 Share Posted August 5, 2020 Profile of red area back to Datum. Use bilateral tolerance, equally disposed . If you select two results you will get min, max, and know which side of Datum it is (overhang or below) Link to comment Share on other sites More sharing options...
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in
Sign In