MasterProbe Planner offset RDS XXT

[[Te...]]

Does any have the correct MasterProbe offset for planner for Calypso 2017 with a Contura 2014 with an RDS XXT. My probe is not touching the part.

[[To...]]

try this. You'll find several replies with numbers very close on Z

[[CA...]]

Hello CMM Form
Now I got in my offline Planner the message:
Well, anyway we are with problem, only a R&R simulator software....Rapid and Reliable fails....uffffffffff

Solution:
1. on the CMM Setting (Extras--Setting--CMM)
2. on the Probe TAB erase the Probe Type by NOTHING
3. then when ask about to eliminate the old stylus (I check YES)
4. begin again from define the Probe...ex: RDS-CAA and so on.
5. create the new set of stylus...