Summary page

[[Jo...]]

Hello,

I would like to make a summary page in my project.

On this summary page I would like to show a table with:

• Total number of measurements
• Number of out of spec.

I can I do this?

Should I make a group of the elements and then with a user defined inspection this value can be found?

 

Johnny

[[Na...]]

Hello Johnny,

in the SW 2022 there is a new tab "Inspection Details", which shows this information:
https://techguide.gom.com/en/gom-software-2022/article/view_inspection_details.html

Regards,
Nanno

[[Jo...]]

Hello Nanno,

I'm not on 2022 but 2019.

And it should be on the report.

Regards Johnny

[[Na...]]

You could create a label with Inspection -> Create Annotation. There is a label template "Results" for this, which will show a pass rate of the visible elements. There are also keywords for elements inside the tolerance, which can be placed on a report page. Make sure to place a 3D-placeholder on the report page with every element on the report page, since the keyword will only consider visible elements.

[[Jo...]]

Hello,

Is this the only way, or can I loop over the inspections of the shown report pages.

Adding a view on a summary sheet and not showing this view is not to convenient.
I have different reports in my file. Each report uses a subset of report pages.

And there are multiple alignments in the report. 1 view is not possible.

I have to think about it.

Johnny

Edited December 21, 2022