[Ia...] Posted July 4, 2019 Share Posted July 4, 2019 Hi Guys, I was hoping I could get some help with this measurement. The R3.619 call out is using a different eccentric centre (y-0.3438). My characteristic is giving me a diameter instead of radius, which is ok, I can deal with that, but it is basing the diameter on the centre of the base alignment. Is there any way to offset this characteristic to the eccentric centre? Link to comment Share on other sites More sharing options...
[No...] Posted July 5, 2019 Share Posted July 5, 2019 You could use the radius measurement characteristic, which outputs every single point of the selected feature as a radius. That output is based on the nominal center of the feature. If you want a single value, define a secondary alignment with the radius center as the origin, recall the diameter to the sec. alignment and evaluate the radius.. Link to comment Share on other sites More sharing options...
[Ia...] Posted July 5, 2019 Author Share Posted July 5, 2019 Thank you Norbert. I had not found the Radius Measurement Characteristic yet. I found it and it seems to be giving me what I need. Link to comment Share on other sites More sharing options...
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in