Radius instead of Diameter

[[Me...]]

Hello,

I have a program that is written to measure conical grooves and then the drawing calls out the center of the conical groove with a dimension from the center of the round part. I can ask for the position of the intersection of the two cones but this gives me a Diameter and to conform to the drawing I need a Radius. It would be a good addition on the tolerance box area to add a check box to apply radius or diameter.
Hopefully someone can point me in the right direction.

Thanks

[[De...]]

From the menu, choose Size -> Standards -> Radius

Then choose your intersection and you will have radius instead of diameter.

[[Me...]]

Thanks for your help, I thought I had seen it couldn't remember where it was!