Jump to content

Measuring a Plane on a Thin Edge


Recommended Posts

117_d8cdbe0c1615d749d14d582babb4eee8.jpg
I have a part that requires me to measure a face that is .015" thick. I can use a .5mm stylus to do this, but their are other features on the part that require a larger stylus size. I don't have a probe changer or anything like that, so I'm restricted to using one stylus for the entire part (old CMM). I was thinking that I could hold a gage block on the top of this face and offset these points to the thickness of the gage block which would then represent this face. I don't know of a way to offset the points. Anyway, I'm open to suggestions.
Link to comment
https://qualityforum.zeiss.com/topic/21132-measuring-a-plane-on-a-thin-edge/
Share on other sites

why not use circle path for the end radial section. Since you are aligned you can do some quick math and place the paths centerline , adjust the diameter, and limit the path to 180 degrees. Do the same for the other end . Add a poly line for each side and you're done. Since the probe will track exactly where you told it to, you can use a larger probe without worrying about it falling off the edges. The first time you do this it will take a bit of time , but it gets easier as you do more. 🙂
Excuse my Power Point, haven't done it since high school... 🤣

I use Formulas a ton in my programs for a lot of lazy things. My instructions are only for measuring a thin wall plane...There's a billion different ways to use Formulas and typically they are used with Result Element.

Formulas.pdf

×
×
  • Create New...