[ZE...] Posted March 26, 2018 Share Posted March 26, 2018 We have a .5012/.5020 diameter but are only able to scan 40% of a diameter. We are getting 600 points and it gives us a reading that is smaller than the actual pin that will go in the pocket. We are getting a measurement of .5011 and a .5015 pin will go in the pocket. If we take 7 equally spaced points we get a larger diameter but still smaller than the pin that will go in the pocket. Anyone have any suggestions. I have it on LSQ in the evaluation. Jimmy Garst | 03-22-2018 04:17 PM | Link to comment Share on other sites More sharing options...
[ZE...] Posted March 26, 2018 Author Share Posted March 26, 2018 It's a cylinder right? any pics or print? Dave Scott! | 03-22-2018 06:44 PM | Link to comment Share on other sites More sharing options...
[ZE...] Posted March 26, 2018 Author Share Posted March 26, 2018 We have tried it both ways, it is close to the same as a circle or cylinder. We were reporting just the circle though. Jimmy Garst | 03-24-2018 10:34 AM |SHPM_Copier18032405460.pdf Link to comment Share on other sites More sharing options...
[ZE...] Posted March 26, 2018 Author Share Posted March 26, 2018 Found it! The pockets are out of round. The supplier is taking 7 points and getting close to the size of the pin that will go in the pocket. When we scan it, it is taking the out of round condition into account when calculating the diameter. This will be up to the Engineers to decide what they want to buy. Jimmy Garst | 03-24-2018 04:26 PM | Link to comment Share on other sites More sharing options...
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in